The Wittmann Tempro Plus D 360 is a powerhouse in the world of temperature control units (TCUs), designed to handle the rigorous demands of large-scale plastic injection molding. If you’ve just downloaded the manual or are looking to optimize your unit, this post covers the essentials—from its standout features to critical maintenance tips.
| Alarm Code / Symptom | Likely Cause | Solution |
| :--- | :--- | :--- |
| Low Flow / Flow Alarm | Pump cavitation, closed valve, or clogged filter. | 1. Bleed air from the pump (bleed screw).
2. Clean the Y-strainer.
3. Check hose connections. |
| High Temp Alarm | Setpoint exceeded; cooling water failure. | 1. Check if cooling water supply is open.
2. Check if cooling solenoid valve is stuck closed. |
| Low Temp Alarm | Heater failure or cooling valve stuck open. | 1. Check contactors/heaters.
2. Inspect cooling valve for debris holding it open. |
| Leakage Alarm | Internal or external leak detected. | Check float switch in drip tray or expansion tank level. |
| Pump Noise | Air lock or worn bearings. | Bleed the pump shaft seal or replace bearings. | Wittmann Tempro Plus D 360 Manual
The most common operational errors occur during startup. According to the Wittmann Tempro Plus D 360 Manual, follow this strict sequence: The Wittmann Tempro Plus D 360 is a
If you have lost your physical manual, the digital version describes a user-friendly but nuanced interface. The Tempro Plus D 360 features a backlit LCD screen and a membrane keyboard. Here is the manual’s breakdown of the key commands: Use a 5-wire (L1, L2, L3, N, PE) cable of min
Alarm E-04 (Over temperature)
“We’ll be down for three days,” Leo said. “The hospital order goes out Monday. Get your toolbox.”
“Can we hot-wire it? Bypass the heater?”