Sss6698bb Format Tool ✰
is a high-performance USB 3.0 flash drive controller manufactured by Solid State System (3S)
3. Prerequisites
- Target drive: USB flash drive with SSS 6698-BB controller (check using ChipGenius or USBDeview)
- Operating System: Windows 7, 8, 10, or 11 (32/64-bit). Run as Administrator.
- Antivirus: Temporarily disable real-time protection – low-level tools can be falsely flagged.
- Backup: All data on the target drive will be lost forever.
Advanced Settings (password often 320 or 1111)
- Flash ID Check – validates that NAND matches controller’s supported list.
- Write CID – writes new card identification data.
- Pre-format – for NAND that has never been MP’d before.
- Erase All Blocks – true electrical erase (not recommended on worn-out drives).
- Firmware Path – selects ISP file (
.bin or .fw) – critical: wrong firmware = dead drive.
Note: Using MPTools carries a risk of permanently "bricking" the device if the wrong firmware is applied. Always try the Kingston Format Utility first if your drive is from that brand. sss6698bb format tool
- Look for the "Flash ID" or "Memory Type". The tool should auto-detect the NAND flash memory.
- Ensure the "Partition Type" is set to "Public" or "Removable."
- Check the "Capacity" setting to ensure it matches your drive's true size (e.g., 16GB).
0MB Capacity: The drive shows up but reports having no storage space. Before You Start: Identify Your Controller is a high-performance USB 3
How to Use the SSS6698BB Format Tool to Repair Corrupted Flash Drives
If you are reading this, you likely have a USB flash drive or memory card that is misbehaving. Maybe Windows is asking you to "Insert a disk" when the drive is already plugged in, or the drive shows up as RAW format with 0 bytes. If your drive uses the SSS6698BB controller chipset, the SSS6698BB format tool (often referred to as SSS MP Tool) is your best shot at bringing it back to life. Target drive : USB flash drive with SSS
Diskpart "Clean" Command: Open Command Prompt as Admin and type diskpart > list disk > select disk X (your USB) > clean > create partition primary > format fs=fat32 quick.
- Data loss: Any formatting operation can irreversibly delete data; backups are essential.
- Bricking devices: Vendor-specific or firmware-level tools can render devices unusable if interrupted or misapplied.
- Trust and origin: Running unknown binaries risks malware infection or unwanted telemetry.
- Compatibility: Applying the wrong tool to a device model can cause corruption or unsupported states.