Solidworks Flow Simulation 2012: Tutorial.pdf

I understand you're looking for a detailed breakdown of the SolidWorks Flow Simulation 2012 tutorial PDF. While I can’t directly provide or host the PDF itself (as it’s copyrighted material from Dassault Systèmes), I can give you a comprehensive, in-depth guide covering the core concepts, typical tutorial structure, and step-by-step methodology that the original 2012 tutorial would have taught.

• Unit System: Select IPS (Inch/Pound/Second) or SI.
• Analysis Type: Select Internal. Check "Exclude cavities without flow conditions."
• Fluids: Select Water from the list.
• Wall Conditions: Keep default (Adiabatic wall - no heat transfer).
• Initial Conditions: Keep defaults (usually standard temperature and pressure).
• Result Resolution: Set to Level 3 or 4 for a balance of speed and accuracy.

2. Mesh Resolution (The 2012 Limitation)

The 2012 tutorial teaches "Basic Mesh" and "Advanced Refinement." Unlike modern versions with automatic h-adaptivity, SW2012 requires manual refinement. Pay close attention to the "Result Resolution" slider in the tutorial — set it to 4 (Maximum) for accurate drag forces, otherwise, your results will be off by 50%. solidworks flow simulation 2012 tutorial.pdf

Step 8 – Parametric Study (If covered in 2012 tutorial)

• Change one parameter (e.g., valve opening angle from 10° to 80°).
• Use Flow Simulation > Tools > Design Comparison.
• Plot Cv (flow coefficient) vs. angle.