Rm-0145 — Manual [patched]

The RM-014S+ (often referred to as the RM-014S or RM-0145) is a popular universal remote designed for LED and LCD TVs. Setting it up allows you to control multiple television brands—such as Samsung, LG, Sony, and Sharp—using a single device. Method 1: Direct Brand Setup (Fastest)

Hardware Description

Front Panel

• Status LEDs:

  while removing and re-inserting the batteries, though a standard factory reset

  Battery Issues: If the indicator light is dim or the remote becomes unresponsive, replace both AAA batteries immediately.

  Diagnostics & Troubleshooting

  • PWR off: Check supply voltage and fuses.
  • RUN LED off but PWR on: Firmware fault — attempt reboot; if persists, reload firmware via USB.
  • ERR LED on: Check error code in RMConfig (see error list). Common causes: RTC fault, EEPROM corruption, overheating.
  • Inputs not responding: Verify sensor wiring, input configuration (sink/source), and measure voltage at IN terminal.
  • Outputs not switching: Verify relay coil voltage, check mechanical stuck relay, confirm logic state in RMConfig.
  • RS-485 comms fail: Check A/B polarity, termination resistor (120 Ω) at bus ends, correct baud/parity/ID.
  • Ethernet issue: Verify module seating, IP settings, subnet/gateway, cable health.

  Accessing the Interface: Open the RM BackOffice and select the Report Interface icon on the toolbar or navigate to Reports > Report Interface. Creating Report Groups: