Patched — Heidenhain Itnc 530 Error List

The Heidenhain iTNC 530 control provides detailed error messages to help diagnose issues ranging from simple programming mistakes to critical hardware failures. Common Processor and Memory Errors

He re-read the list’s footnote for 4623: Note: Intermittent signal may indicate RF interference or ground loop.

• Error Messages (Red): These stop the machine immediately. The NC stop is triggered, and the spindle/feed halt.
• Warning Messages (Yellow): These indicate an irregularity, but the machine may continue running (though usually, it requires acknowledgment).

Alarm 1800 — Main Supply Undervoltage/Overvoltage

• Cause: Pump electrical fault, low coolant sensor triggered, or clogged line.
• Fix: Check pump power, replace or service pump, inspect sensors and clean filters/lines.

Incomplete Unit Definition (smarT.NC): In the smarT.NC mode, this error often triggers if a machining unit is defined without its corresponding contour description (.HC file) or point table (.HP file).