Gunnebo Speedstile Fl — Installation Manual

Gunnebo SpeedStile FL is more than just a security gate; it is a sophisticated marriage of precision engineering and architectural minimalism

[ ] All glass edges are silent during swing
[ ] Emergency break glass opens both lanes
[ ] Fire alarm input forces open state
[ ] No loose screws inside pedestal (they rattle, and clients hate rattles)
[ ] Manual stored in the pedestal’s pouch (yes, there’s a pouch)

Testing and Verification

Connect the power supply to the SpeedStile FL control unit.
Connect any communication cables (e.g., RS485, TCP/IP) to the control unit.

Run the mains cable to the unit’s power entry gland or junction box. Typical models use 230–240VAC single-phase; check nameplate.
Connect earth/ground first, then neutral and live. Tighten to proper torque and secure strain relief.

Foundation: A flat and level finished floor with a tolerance of +/- 5mm is required. gunnebo speedstile fl installation manual

Install sensors and readers according to the manufacturer's instructions
Connect sensors and readers to the control unit

Backup configuration to a file and store it off-site for quick recovery.